Lightweight Maintenance Enclosure

The LME is a frame supported lightweight shelter designed to provide units with a covered facility to conduct tactical maintenance operations. The LME is a modification of the Tent, Extendable, Modular, PERsonnel (TEMPER) where extensions are added to the tent frame to add the height needed for enclosure of tactical vehicle and equipment. The end walls have been modified with sliding fabric doors permitting total enclosure during conditions of extreme weather or blackout. The LME has 18-inch diameter duct openings in each of the 16 ft. intermediate fabric sections located below the windows. The U.S. Army and U.S. Marine Corps have adopted the LME as their standard maintenance shelter.

LME (Type I) LIN T49947: NSN 8340-01-456-3637 (Type I) Technical Manual TM 10-5410-284-13&P. Operator’s Unit and Direct Support Maintenance Manual, Including Repair Parts and Special Tools List.

The LME has successfully completed military durability, snow and wind loads performed by the US Army Aberdeen Test Center.


10lbs / ft2 for 12 hours


55 mph


65 mph


45 minutes


12 soldiers


463L Pallet


Floor Area 768 Sq. Ft.
Eave Height: 12 Ft
Weight: 1,435 Lbs
Length: 32 Ft
Height: 15 Ft 6 In
Packed Volume: 108 cubic feet

View The Spare/Repair Parts List


  • Three (3) 20 AMP 120VAC circuits and one (1) 10 AMP 120VAC circuit of lights only.
  • Designed to be used with a cable of 25 to 50 feet in length. Military cable type CO-04-MFG 4/8 having four (4) conductors of number eight (8) wire size may be used or the commercial equivalent.
  • Flexible, medium duty commercial type SO having four (4) conductors of wire size number 8 is suitable to connect the PDB to the load terminals for the electric power generator.
  • Three (3) 20A Ground Fault Duplex receptacles for use as utility receptacles
  • One (1) 10A Ground Fault Duplex receptacle for use with lights only


  • Light operates on a voltage of 120 plus or minus 5 volts alternating current at 50 to 60 Hertz.
  • The input current drawn per light assembly is a maximum of 0.7 amps with a minimum power factor of 0.07.
  • Lights are capable of interconnecting a string of up to 12 lights maximum. Each light operates independently of the through power circuit.
  • Light assembly is capable of withstanding 1000 volts AC, 60 Hz between supply terminals and with ground lead grounded.
  • Light Illumination: Illumination greater than 140 foot-candles at a distance of 18” from the center of the light.
  • The lights comply with the RE102 Electric Field 2 MHz to GHz test requirements IAW MIL-STD-461D Requirements for the Control of Electromagnetic Interference Emissions and Susceptibility.
  • The lights comply with Method CE102 Power Leads 10 kHz to 10 MHz IAW MIL-STD-462D for the Measurement of Electromagnetic Interference Characteristics.


Type 1: Army, Marine Corps

Model NSN Item
CMC-1010 8340-01-456-3637 LME TY1 GRN
CMC-1111 8340-01-507-4375 LME TY1 Tan